Eberspacher EasyStart Remote+ Operating instructions Manual de usuario Pagina 31

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 30
VEHICLE HEATERS – TECHNICAL DOCUMENTATION | 31
5 WHAT TO DO IF …?
IN THE EVENT OF A FAULT THE FOLLOWING DISPLAYS ARE POSSIBLE
DISPLAY DESCRIPTION REMEDY / CUSTOMER
Pair mode
Add
Automatic detection is active.
The EasyStart Remote
+
has been dis-
connected from the power supply and
then reconnected.
Wait until the automatic detection has
finished, then set the time and week-
day, see page 27 and 28.
Pair mode
AddE
Battery dead. Replace battery immediately!
NO SIGNAL
No communication Check and if necessary renew the
heater fuse.
Visit your vehicle workshop.
Error
08:30
120 min
1st heater fault. Visit your vehicle workshop.
Error
2nd heater fault. Visit your vehicle workshop.
18:30  °C
Temperature sensor defective. Visit your vehicle workshop.
Vista de pagina 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios