Eberspacher EasyStart Timer Operating instructions Manual de usuario Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
VEHICLE HEATERS – TECHNICAL DOCUMENTATION | 29
4 WHAT TO DO IF …?
IN THE EVENT OF A FAULT THE FOLLOWING DISPLAYS ARE POSSIBLE:
DISPLAY DESCRIPTION REMEDY / CUSTOMER
INIT
Automatic detection is active.
The EasyStart Timer has been dis-
connected from the power supply
and then reconnected.
Wait until the automatic detection has
finished, then set the time and weekday.
NO SIGNAL
No communication. Check and if necessary renew the heater
fuse.
Visit your vehicle workshop.
Error
1st heater fault. Visit your vehicle workshop.
Error
2nd heater fault. Visit your vehicle workshop.
Voltage too low. Charge battery, if necessary visit your
vehicle workshop.
18:30  °C
Temperature sensor is defective Visit your vehicle workshop.
PLEASE NOTE!
If you are unable to remedy the error or fault, please
contact an authorised JE workshop or dial the follow-
ing service phone number.
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32

Comentarios a estos manuales

Sin comentarios